Neff T69S86N0 Manuel d'utilisateur télécharger pdf (Page 16)

Never remove the valve reinforcing ring.

If the by-pass screw cannot be accessed, disassemble

the glass panel and frame described in: Changing the

nozzles for double-flame burners. Fig. 9.

Adjust the minimum ring setting by turning the by-pass

screw using a flat head screwdriver.

To adjust the minimum flame for N.G. replace the control

knob onto the spindle, light the gas and turn the control

knob to the small flame position. Screw the adjustment

screw anti-clockwise to estabilish a minimum stable

flame position. The flame should remain alight and not

burn back to the injector when the valve is turned

quickcly from ‘Full On’ to the “Minimum flame” position

and back a few times. To adjust the minimum flame

position for ULPG the screw must be fully tightened down

clockwise.

Refit the control knobs.

Never remove the tap spindle. In the event of a

malfunction, change the whole tap.Fig. 14.

Warning! After finishing, the sticker indicating the new type

of gas must be placed close to the specifications plate.

Fig. 14

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Pas de commentaire

Neff T69S86N0 Manuel d'utilisateur Page 16